The wiring for the MicroSquirt is complete. I still need to complete the wiring for the drive by wire system, install the mechanical fuel pump, bolt down the fuel filter/high pressure pump and install the spark plug wires. The weather is not looking great, but I hope to be able to start it this weekend.
The VR sensor and trigger wheel are mounted, the tabs to hold the wiring for the VR and O2 sensor wires are in place, the fuel pressure regulator is mounted, the fuel rails have been fully machined, hold downs made and installed and the coils have been mounted. I need to get a few fuel lines and start the wiring.
The intake manifold is finished and installed on the boat. I've tested the fit of the injectors, fuel rail and throttle body and I'm very happy with how it has all worked out. I still need to make the fuel rail hold downs, but the sensors are all installed in the manifold.
